Telecom & Data

تصنيع وتسليم11 منتجات

المتطلبات · 11

What this sector arrives with

نصلم يُكتب بعد

A 48 VDC plant that has to survive a bad grid without a site visit — redundancy, low-voltage disconnect, remote alarms — or a wide-input stabiliser for equipment on a network that swings outside tolerance. Lead with the redundancy and monitoring architecture.

الفئات التي تخدم هذا القطاع · 05الأعداد هي المنتجات التي تخدم هذا القطاع

Voltage Regulation & Power Conditioning

Servo, IGBT static and relay-controlled AC voltage regulators, plus harmonic and surge filtering.

Battery Chargers & DC Systems

Grid-station, telecom, industrial and specialist battery chargers with DC distribution and battery banks.

Step-down, isolation, rectifier-duty, control and waterproof transformers wound to order in pure copper.

DC Power Supplies & Rectifiers

Thyristor-controlled plating and process rectifiers from a few amps to 20,000 A, and variable laboratory-grade DC supplies.

Panels, Distribution & Controls

AC and DC distribution boards, SCR heat control, PFI, ATS, motor starters and protection relays.

منتجات لهذا القطاع · 11التصنيفات تكوينات قياسية · التسعير عند الطلب

Automatic Plating Rectifier

Thyristor-controlled, closed-loop DC supply for electroplating lines — low-voltage, very high current, with optional periodic reverse.

0–60 VDC · 100–20,000 A

Telecom Battery Charger 48 VDC (1+1 Redundant)

Dual-module 48 VDC power system built to telecom specifications, with N+1 redundancy and load sharing from 30 A to 200 A.

1–415 VAC · 30–200 A

Floating Battery Charger 24 VDC

Compact 24 VDC float charger, 20-70 A, for communications, signalling and vehicle-battery duty.

220 VAC · 20–70 A

Battery Banks, Stands & Fuse Boxes

Matched battery banks with stands, inter-cell links and fused isolation, supplied and commissioned with the charger.

110 VDC 400 Ah with battery fuse box

Servo-Controlled Automatic Voltage Regulator

Motorised-variac AVR from 500 VA to 300 kVA holding output within ±1-2% against a ±25% input swing, with no added waveform distortion.

380 VAC ±1% to ±2%, 3-phase; 220 VAC ±1-3%, 1-phase

IGBT-Controlled Static AVR

Transformerless-tap static regulator, 2-100 kVA, correcting to ±1% in milliseconds with no moving parts.

2-15 kVA single-phase; 5-100 kVA three-phase

Relay-Controlled Voltage Stabiliser

Economical stepped-tap stabiliser, 300 VA to 8 kVA, with a very wide 90-280 VAC input window for weak distribution networks.

220 VAC regulated

Harmonic Filter

Passive filter delivering a clean sine wave to sensitive electronic loads on distorted supplies.

Step-Down Distribution Transformer

Dry-type LT step-down transformers, 5-300 kVA, typically 380-415 VAC 3-phase to 208/120 VAC, wound in pure copper.

5 kVA to 300 kVA (30-150 kW commonly supplied)

Isolation Transformer

1:1 galvanic isolation transformers, 5-300 kVA at 415/415 VAC 3-phase, for solar, UPS and sensitive-load installations.

5 kVA to 300 kVA (10-100 kVA commonly supplied)

DC Distribution Board (DCDB)

Compartmentalised DC distribution boards with per-circuit MCBs, monitoring and earth-fault detection, up to 20 outgoing ways.

24 / 48 / 110 / 220 VDC

غير مُدرج

تصنيف خارج هذه التكوينات

أرسل جهد التغذية والخرج المطلوب ودرجة حماية الحاوية ودرجة حرارة الموقع. نُسعِّر على المنصة نفسها المستخدمة في التكوينات المُدرجة.

طلب عرض سعر

القطاعات